Suburban Tool, Inc. Taft-Peirce Metrology Workholding & Inspection Equipment

SEARCH KEYWORDS

COMPOUND SINE PLATES

PROUDLY MADE IN OUR FACILITY IN THE U.S.A. ASK OUR COMPETITION IF THEY CAN SAY THE SAME.

SPC-66-S1 SPC-612-S2

Made of steel, hardened to Rc 58-60.   Sizes up to 6" x 6" have 1/4-20 tapped holes. Larger sizes have 3/8-16 tapped holes.   Models with the suffix S0, S1 or S2 are part of the SineSet® System.  Other products with the same part # suffix will bolt directly to these sine plates (for compatibility chart click here).   Each gage block roll has two 0.200" minute steps for setting small angles with standard gage block sets.   Two locking straps that always remains below the top surface and two hardened & ground rails are standard.

MODEL # SineSet® SERIES L W H C1 C2 SQUARE & PARALLEL WT (#) SPC-44-S0 S0 4" 4" 3-1/8" 3" ±0.0002" 3" ±0.0002" 0.0002" 13 SPC-66-S1 S1 6" 6" 3-1/8" 5" ±0.0002" 5" ±0.0002" 0.0002" 27 SPC-612-S2 S2 12" 6" 4-3/16" 10" ±0.0002" 5" ±0.0002" 0.0003" 71 SPC-618-S2 18" 5-3/8" 15" ±0.0003" 0.0004" 134 SPC-812-S2 12" 8" 4-3/16" 10" ±0.0002" 0.0003" 93 SPC-1212-S2 12" 10" ±0.0002" 137 SPC-1218-S2 18" 5-3/8" 15" ±0.0003" 10" ±0.0003" 0.0004" 257

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE SPECIAL SIZES AVAILABLE UPON REQUEST

Copyright © 2001-2010 - Suburban Tool, Inc.     All rights reserved. All trademarks and logos shown are the property of their respective owners.

4141 N. Atlantic Boulevard, Auburn Hills, Michigan 48326 Phone:  (248) 391-7800     Fax:  (248) 391-7462 E-mail:   tools@subtool.com