Suburban Tool, Inc. Taft-Peirce Metrology Workholding & Inspection Equipment

SEARCH KEYWORDS

PERMANENT MAGNETIC COMPOUND SINE PLATES

PROUDLY MADE IN OUR FACILITY IN THE U.S.A. ASK OUR COMPETITION IF THEY CAN SAY THE SAME.

MSPC-66-S1              MSPC-612-FP-S2

All chucks use ceramic magnets for superior holding power.   Chucks are lubricated and sealed against dirt and liquids.   A removable handle and two rails are included with each chuck.   Two locking straps and two self-storing, hardened & ground rails are included with each SineSet® compound sine plate.   The gage block roll has two 0.200" minute steps for setting small angles with standard gage block sets.   Models with the suffix "S0, S1 or S2" are part of the SineSet® System. The chuck can be removed, allowing the individual use of both the compound sine plate and magnetic chuck and allowing other products with the same part number suffix to bolt directly to the compound sine plate (for compatibility chart click here).   The compound sine plate portion is made of steel, hardened to Rc 58-60.   STANDARD POLE:  1/4" poles and 1/8" separators produce deep flux lines for holding large and thick parts. FINE POLE (marked -FP):  1/8" poles and 1/8" separators produce shallow flux lines for holding small and thin parts.

MODEL SineSet® SERIES L W H C1 C2 SQUARE & PARALLEL WT(#) STANDARD FINE POLE STD. F.P. SineSet® COMPATIBLE -- MSPC-44-FP-S0 S0 4" 4" 5-3/4" 3" ±0.0002" 3" ±0.0002" 0.0002" -- 25 MSPC-66-S1 MSPC-66-FP-S1 S1 6" 6" 5-3/4" 5" ±0.0002" 5" ±0.0002" 0.0002" 48 52 MSPC-612-S2 MSPC-612-FP-S2 S2 12" 6" 6-13/16" 10" ±0.0002" 5" ±0.0002" 0.0003" 113 118 MSPC-618-S2 MSPC-618-FP-S2 18" 8" 15" ±0.0003" 0.0004" 199 204 MSPC-812-S2 MSPC-812-FP-S2 12" 8" 6-13/16" 10" ±0.0002" 0.0003" 151 156 MSPC-1212-S2 MSPC-1212-FP-S2 12" 10" ±0.0002" 237 243 MSPC-1218-S2 MSPC-1218-FP-S2 18" 8" 15" ±0.0003" 10" ±0.0003" 0.0004" 408 417 NOT SineSet® COMPATIBLE (CHUCK IS NOT REMOVABLE) MSPC-66 MSPC-66-FP -- 6" 6" 5-3/8" 5" ±0.0002" 5" ±0.0002" 0.0002" 44 48

!!!!!     FOR IMPORTANT HOLDING POWER INFORMATION CLICK HERE     !!!!!

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Copyright © 2001-2010 - Suburban Tool, Inc.     All rights reserved. All trademarks and logos shown are the property of their respective owners.

4141 N. Atlantic Boulevard, Auburn Hills, Michigan 48326 Phone:  (248) 391-7800     Fax:  (248) 391-7462 E-mail:   tools@subtool.com