Suburban Tool, Inc. Taft-Peirce Metrology Workholding & Inspection Equipment

SEARCH KEYWORDS

Master-Grind™ INDEX FIXTURE

PROUDLY MADE IN OUR FACILITY IN THE U.S.A. ASK OUR COMPETITION IF THEY CAN SAY THE SAME.

MG-5CV-S1 Front View

MG-5CV-S1 Rear View

V-Block and 5C collet in one fixture.   72 position index plate provides a hard stop every 5° ±15 arc seconds.   Built in sine bar for setting angles between hard index locations.   Horizontal or vertical v-block mounting   Spindle runs in two heavy duty 4" diameter tapered roller bearings.   Maximum spindle runout of 0.00005".   Fitted wooden case included.

FULL 24 MONTH WARRANTY

MODEL # SineSet® SERIES COLLET CAPACITY V-BLOCK CAPACITY THROUGH HOLE C L1 L2 W H SQUARE & PARALLEL WT(#) MG-5CV-S1 S1 ALL 5C 1-5/8" 1-1/4" 3" 8-15/16" 5-3/16" 5" 5-1/2" 0.0002" 22

Covered by design patent D327077.

ACCESSORIES FOR THE Master-Grind™ INDEX FIXTURE

MOTOR DRIVE KIT

MG5-MD

Optional MG5-MD shown on MG-5CV-S1

1/15 HP, reversible, variable speed, 60 to 300 RPM.   Can be mounted on either side of the index fixture.   Includes mounting bracket, motor pulley, drive belt & screws.

BASE & TAILSTOCK

MG5-BTS

MG-5CV-S1 shown on optional MG5-BTS

Tailstock has 1/2" diameter x 60°, spring-loaded center with locking screw.   Baseplate and edge guide are hardened and ground.   1/2" 5C collet and 60° headstock center included.

Note:  Factory fitting of the MG5-CV-S1 to the MG5-BTS is required.   This is included at no charge, even when the Baseplate & Tailstock is purchased separately from the Index Fixture.

MODEL # DESCRIPTION LENGTH WIDTH HEIGHT CAPACITY WEIGHT(#) DIAMETER LENGTH MG5-BTS BASEPLATE & TAILSTOCK 16-7/16" 5-1/2" 4-23/32" 5-3/4" 7-1/4" 22 MG5-MD MOTOR DRIVE KIT 8-5/32" 3-15/16" 5-5/32" -- -- 5

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Copyright © 2001-2010 - Suburban Tool, Inc.     All rights reserved. All trademarks and logos shown are the property of their respective owners.

4141 N. Atlantic Boulevard, Auburn Hills, Michigan 48326 Phone:  (248) 391-7800     Fax:  (248) 391-7462 E-mail:   tools@subtool.com